Water heaters are non-issues UNTIL you get struck with that first icy shower or giant puddle in the basement. Then you need to think quickly: should one repair or replace?
If it’s a conventional storage-tank water heater nearing completion of its 10-13-year life, replacement is obvious. New models depend on 20 % more effective and can conserve up to $700 in energy expenses over the life of the system. Nonetheless, if your water heater is only a couple of years old, repair work could be the way to go. Not sure whether to fix or change? Let us know and we can assess the need for an Orlando Water Heater Replacement with you.
Which Type is Best?
There are two types of traditional water heaters, gas and electric. An electric water heater can be used nearly anywhere. A gas water heater is most likely to be set up in a home that already makes use of gas for an additional appliance such as a furnace or stove. Building codes could dictate the placement of gas water heaters, restricting them to areas outside of regular home activity.
It is most likely if you are replacing a water heater, you’ll merely replace it with the exact same type of system that was already there. Nevertheless, there are upgrade possibilities that must be considered. For instance: if area permits, you might decide to enhance the unit’s holding ability to accommodate your expanding family. Another essential factor to consider is the unit’s energy efficiency. Replacement time is the best time to lower your energy bill by selecting a water heater that is more energy effective.
When trying to find a water heater, consider these attributes
Gallon capability (40-gallon and 50-gallon heaters are most typical).
Recovery rate (the number of gallons the heater will warm in an hour).
Dimensions (width and height– physical area may limit your ability to update your system’s capacity – will the heater fit in the area you have for it?).
The energy efficiency rating (a sticker on the side must note the estimated yearly cost of operation for the system).
Before making any repairs or purchasing a new water heater, inspect the nameplate on the side of your current unit. Below you will find practical information consisting of the tank capacity, insulation R-value, setup standards, working pressure, model and identification number. If you have an electric water heater, the nameplate will also note the wattage ability and voltage of the heating aspects.
Let us know if you have any questions!
Back to Water Heater Repair Orlando…