Gas Water Heater Troubleshooting Advice

Posted by on Oct 31, 2013 in Gas Water Heater Repair Orlando, Water Heater Repair Orlando

So the gas water heater in ones home is not doing as well as it should? It is normally among just a couple of things that will go wrong with the unit. Review these concepts below to see if you have the ability to assess what the cause may be. We can be reached anytime to assist with this Gas Water Heater Repair as well!

Pilot Lights

Gas hot water heater repairing always appears to begin with the pilot light. The majority of gas hot water heaters us a pilot light to ignite the burner. There are some more costly models that utilize electronic ignition. When the pilot light is out or won’t remain on, you will not have hot water.


The thermocouple is a sensor that informs the gas valve when to allow gas to stream to the burner. Gas hot water heater repairing commonly includes the thermocouple. When they go bad the will not allow the gas valve to release any gas. No gas, no hot water.


The thermostat is part of the gas valve. There is not a lot that can be done to fix one that is bad, short of replacing the gas valve. The major interested in the thermostat is getting the temperature level correct. Water that is too hot can be dangerous. Discover exactly what the proper settings are.

Gas Valves

The gas valve controls the gas that goes both to the pilot light and the primary burner. It utilizes the thermocouple to determine when it is safe to release the gas. It also makes use of an important thermostat to learned when more heat is required. Explosions can result from gas that is not burned. For that reason the water heater gas valve has safety gadgets developed in.


Blockages in the vent pipe can limit the air flow to your water heater. This will trigger the burner to run badly. It can indicate a reduced amount of hot water. Terribly congested vents will result in unsafe gases developing up in the house.

Here is a nice video on routine maintenance tasks for a gas water heater: